D.T.S. JACK Manuel d'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
15
11.1-DMX Addresses
JACK can be used in 2 different DMX modes: 25 DMX control channels (Default) or
17 DMX control channels.
Here below is described the DMX channels addressing for the controller when JACK is
set to 25 and 17 DMX control channels:
25 channels mode (Default)
Projector 1 A001
Projector 2 A026 If you want to select the next projector, just add “25
Projector 3 A051
….. A….
projector 6 A126
17 channels mode
Projector 1 A001
Projector 2 A018 If you want to select the next projector, just add “17
Projector 3 A035
….. A….
projector 6 A086
11.2-Selecting the DMX address
1) Press the UP-DOWN key until you reach the required DMX channel. The numbers
on the display will start to flash (but the new DMX address hasn't yet been set).
2) Press ENTER to confirm your selection. The numbers on the display will stop
flashing and the projector is now setted to the new DMX address.
TRICKS:
If you keep pushed the UP or DOWN keys, the channels are calculated more quickly
and you get a faster selection.
12- FIRMWARE UPDATING
Warning:
This procedure require a base knowledge of computer applications and Windows
Hyperterminal program. Please refer to an authorised D.T.S. service centre.
To update the software version of the JACK you need:
D.T.S. RED BOX interface (D.T.S. Code: 03.LA.008).
USB-DMX Driver for the D.T.S. RED BOX interface.
(The driver and the installation procedure are available in our web site
www.dts-lighting.it)
Updating the software version.
Please follow the procedure below to perform the update:
1. Install the D.T.S. RED BOX USB-DMX driver on the PC you will use to update the
unit software.
2. Connect the D.T.S. RED BOX interface to the PC by using a USB cable.
3. Connect the D.T.S. RED BOX interface to the fixture by using a DMX cable.
4. Download the new software version into the unit by using Windows Hyperterminal
program.
It will be possible to download the software from the reserved area of D.T.S. web site:
www.dts-lighting.it.
!
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Commentaires sur ces manuels

Pas de commentaire